Gateway 910 Series, System Manual, Page: 36 / 129

28
Replacing or Adding System Components
Replacing the diskette drive
The diskette drive is included in the original configuration. If you need to
replace the diskette drive, perform the following instructions.
To remove the diskette drive:
1
Observe the safety and ESD precautions in “Preventing static electricity
discharge” on page 15.
2
Turn off the server, then disconnect the power cord(s), modem cable (if
installed), and all external devices.
3
Remove the cover panel. (See “Removing the cover panel” on page 17.)
4
Remove the bezel. (See “Removing the bezel” on page 19.)
5
Disconnect the power and data cables, noting their locations and
orientations. (You will reconnect these cables after you install the new
drive.)
6
Push the drive release latch toward the back of the server (unlocked
position).
7
Pull the drive out of the chassis and place it in an antistatic container.
Drive
release latch