T1 CrossConnect Installation & Operation Manual
6 – Configuration Using ISiCL
Version 2
6-18
GatesAir
Intraplex Products
The
MAPIND
command enables the contact closures on the MA-251A to change immediately when a
map change is made. Use this commands to set MAPIND on or off:
::SET:MAPIND=ON;
::SET:MAPIND=OFF;
●
When
MAPIND=ON
, the contact closures on the MA-251A changes immediately when a map change
is made. The jumper labeled JMP 1 on the MA-251A must be removed to enable
MAPIND=ON
to
take effect.
●
When
MAPIND=OFF
, the contact closures do not change immediately upon a map change.
The default setting is
MAPIND=OFF
.
MAPIND
should always be turned off unless immediate reporting
via the Status Port contact closures is necessary, since a change in map number may result in an
interruption of other ISiCL communication.
Note:
The
MAPIND
command can only be used if the CM-95E is Rev. A4 or higher, and is installed
with an MA-251A, not an MA-251.
To change the map number under the default conditions, use this command:
:DACS:SET:MAP x=ON;
(where
MAP x
=0-7)
6.15.4 DS0 Parameter
The DS0 parameter allows you to specify time slot settings on a port by port basis for any map. The
syntax is:
::SET:DS0,<m>,<p>,<ts>=<p>,<ts>;
where
m
is the map number;
p
is the port; and
ts
is the time slot number. The value for the DS0
parameter follows the equal sign. For the value, you must specify both a port and a time slot number.
As an example for map 3, suppose you want port 5, in time slot 21, to receive signals from port 1,
time slot 18. You would set the
DS0
parameter as
::SET:DS0,3,5,21=1,18;
6.15.5 CONFIG? Command
Use the
CONFIG?
command to view the current map configurations. The complete command syntax is
::CONFIG?:DS0,<m>,<p>,<ts>;
where
m
is the map number;
p
is the port; and
ts
is the time slot number. To view how a specific time
slot is configured, enter
::CONFIG?:DS0,<m>,<p>,<ts>;
To view how all the time slots on one port are configured, enter
::CONFIG?:DS0,<m>,<p>;
To view how an entire map is configured, enter
::CONFIG?:DS0,<m>;
This example requests a display of the configuration for time slot 13 on port 5 in map 2:
::CONFIG?:DS0,2,5,13;
Summary of Contents for Intraplex T1 DCS-9500 CrossConnect System
Page 2: ......
