- 60 -
Dome Camera (CAMICAGSC) Installation and Configuration.
Dome Camera (CAMICAGSC) Installation and Configuration.
Dome Camera (CAMICAGSC) Installation and Configuration.
Dome Camera (CAMICAGSC) Installation and Configuration.
Routing the C
Routing the C
Routing the C
Routing the Camera Harness(es)
amera Harness(es)
amera Harness(es)
amera Harness(es) )))) (
(
(
(GSWHC2
GSWHC2
GSWHC2
GSWHC2----XX)
XX)
XX)
XX)....
Route the camera harness(es) with labeled end at NiTRO™ connections.
Always use grommets when running the harness through sheet metal holes.
Avoid excessively tight bends especially around metal surfaces..
Coil and tie off excess harness in a safe place.
NOTE:
NOTE:
NOTE:
NOTE: Determine appropriate mounting location. Keep in mind the lens size may be different
from camera to camera, check with transportation director or immediate supervisor for lens
configuration.
Disassemble the dome camera by removing the
outer polycarbonate dome. Loosen Phillips screws
to allow camera board to move freely.
Ensure the included gasket is in place between dome
baseplate and mounting surface. This gasket is
required as it acts as a cushion to absorb vibration
and aid in elimination of wind noise from the roof of
the bus. Determine seat position for camera harness
and insert camera harness into seat position, as
shown below
Camera Gasket
Use the FRONT label as your guide.
Ensure the Lens/Microphone
assembly is located directly above the
FRONT label.
Attach the Molex connector
from camera harness to the
Molex connector attached to
the camera circuitry.
Focus camera by referring to ‘Focusing Camera Lens’.
After final check re-attach Polycarbonate dome cover and outer dome with hex screws.
Do not clean Polycarbonate dome with any agents.
- 9 -
Product Overview
Product Overview
Product Overview
Product Overview: NiTRO
: NiTRO
: NiTRO
: NiTRO----X
X
X
X
400 Series.
400 Series.
400 Series.
400 Series.
DVRIDVMDR-401XAV - NiTRO-X
Single-Channel H.264 SD Recorder
DVRIDVMDR-401XLAV - NiTRO-X
Single-Channel H.264/LED SD Recorder
DVRIDVMDR-404XAV - NiTRO-X
4-Channel H.264 SD Recorder
DVRIDVMDR-404XLAV - NiTRO-X
4-Channel H.264/LED SD Recorder
NiTRO-X
400 Series
NiTRO
Power Harness.
(P/N: CAB000262 (6pin) 30’)
S-Series Camera
Sensor Harness CAB000218
Alarm Button (SMARTFLAG)
Camera Harness(GSWHC2N-XX)
Available in 15’; 30’ and 60’ lengths
Camera Adapter Harness (CAB000209)
Camera Adapter Harness (CAB000202)
