- 22 -
Suggested Camera Locations.
Suggested Camera Locations.
Suggested Camera Locations.
Suggested Camera Locations.
Check For:
•
Ceiling mount recommended.
•
Do not obstruct walkways.
•
Avoid contact with abrasive metal to
prevent short circuits.
Three Camera Configuration
Wire Routing:
•
Camera harness to be connected through
opening in base.
•
Use existing wire paths wherever possible,
radio, speakers, etc.
•
Avoid excessively tight bends especially
around metal surfaces.
•
Always use grommets when routing
through sheet metal holes.
•
Coil and tie off excess harness or tuck up
into ceiling.
Four Camera Configuration
Alternate Four Camera Configuration.
- 47 -
Using The Calendar Feature.
Using The Calendar Feature.
Using The Calendar Feature.
Using The Calendar Feature.
It is recommended that MaxVIEW
be run utilizing Calendar View as this will reduce the
amount of time required to load the video ready for playback.
To view video files by date within MaxVIEW
400 click on the
View menu and from there select the Clip Filter option and
finally By Date, This will bring up Calendar view.
Figure 33 : Calendar Feature.
Calendar Definitions.
Calendar Definitions.
Calendar Definitions.
Calendar Definitions.
The Calendar feature can be broken down into Four main
parts:
1.
Displays the Month of the selected video files.
2.
The Dates in Bold, (circled), are dates for which there is
available video for Playback.
3.
The Date highlighted is the date of the current video
being reviewed.
4.
Highlighted line is the start time for the current video
being reviewed and also displays the ID of the vehicle.
Figure 34 : Calendar Definitions.
To navigate through the list of available clips in Calendar view use the Next (5) Button or the
Previous (3) Button as shown in Figure 36. As each clip is accessed using either of these
buttons the main Playback Window and the Thumbnails will change to reflect the changing
video being accessed.
View Video by Clips.
View Video by Clips.
View Video by Clips.
View Video by Clips.
To view all video files within MaxVIEW
400 click on the
View menu and from there select the Clip Filter option and
finally All Clips, This will bring up the Clips view.
