CartManager XD+ Owner-Operator Training and Troubleshooting Guide
Page 34
Place pallet jack under bucket on
same side as wheel being changed.
Block rear and opposite wheels.
9.
Attach the new swivel wheel assembly. Tighten the bolts securely.
10.
Place the jack, remove the wood blocks and lower CartManager XD+ back down.
11.
Remove all tools and materials from the area.
Replacing the Main Drive Tires
The foam-filled main drive tires are designed to give maximum traction and durability over a wide range of working
conditions and surfaces. The only time you should need to replace a tire is in the case of excessive wear or damage.
If you need to replace both tires, do them one at a time.
You will need:
•
1 or 2 replacement foam-filled tires, part #A500129,
•
A car jack, ball jack, or similar type of device capable of lifting at least 750 pounds
•
4
wheel
chocks,
•
Several sturdy wood blocks,
•
A 3/4” (19 mm) socket, socket driver and a short extension.
1.
Park CartManager XD+ in a dry, flat area.
2.
Make sure the unit is turned off and the that the manual brake lever is pushed all the way in.
3.
Wedge a wheel chock in front and in back of the wheel you are NOT working on.
4.
Wedge 2 chocks to immobilize the back swivel wheel.
5.
On the wheel being replaced, use the 3/4” (19 mm) socket to loosen the nuts about ½ turn. DO NOT remove the
nuts completely.
6.
Place the jack under the side panel on the same side as the
wheel being changed, as shown in the diagram below.
7.
DO NOT use a forklift or pallet jack to lift
from under the metal shroud that protects
the motor and axle assembly; you will
damage the shroud.
8.
Lift CartManager XD+ so that you have just enough room to slide the new tire on.
9.
Wedge the wood blocks under the front corner of the CartManager XD+. This provides an extra safety measure in
case the jack shifts.
10.
Remove the nuts and pull the tire straight off the bolts.
11.
Slide on the replacement tire and tighten the nuts.
12.
Lower the jack and remove all tools and materials from the area.
