put over the plug:
Possible malfunctions
Safety thermostat / fire protection triggers mecha-
nically
The device no longer heats up, but the display flashes.
In addition to electronic temperature monitoring
and electronic fire protection, our pasta cookers have
mechanical fire protection. If the electronics do not
work properly and the device overheats or the water
level is too low, the safety thermostat responds at a
temperature of> 230 ° C and automatically interrupts
the heating circuit.
A red reset button is located on the cover on the
fitting box in the interior of the control. To do this, an
experienced person must unlock the control with the
key. This can be pushed up and thus reset. If the safety
thermostat switches off several times, service must be
requested.
Machine has no function, display dark
• check the fuses of the electrical supply line.
• is the plug inserted?
• is the main switch switched on (on site and
device)?
• is the safety thermostat activated?
If you are unsuccessful, call our service department
0041 71 855 8070, or email: [email protected]
Warning message Error 1, PT-100 / PT-1000
The machine does not receive any current tempera-
ture or has an interruption to the PT-1000 sensor and
therefore cannot switch on. (Fire hazard)
• Check the plug contacts to the PT-1000
• Ohm measured value PT-1000 at 25 ° C -> R =
1.008 kΩ
Maintenance and customer service
In the event of malfunctions, contact Gastro-frit AG
in Rorschach, Switzerland Tel. 0041 71 855 8070. The
device may only be repaired and connected by trained
specialists.
Note: (only for repair service with Gastrofrit® training):
Attention! All power circuits must be
switched off before access to the connection
terminals.
Important: Please state the device type and number
(inside of the door) with every report to the service
point.
It is recommended to enter the type and the number
below. Regular maintenance can extend the life of
your device.
Maintenance
We recommend regular maintenance by our customer
service. A distinction can be made between two
maintenance models. More detailed information on
the service contracts: 0041 71 855 8070 or
www.gastrofrit.ch.
Cleaning
Devices
Heating standard
The heating element can be pulled out and rotated.
The difference to the plug-in version is that these are
not removed.
1. Turn off the device. Press:
2. Empty the interior. There must be no contents
(baskets, pasta residues or cleaning water!) In the
cooking basin.
3. Let the heating cool down to 35 ° C (hand warm).
4. Pull out the heater and turn it slightly to the left.
5. The pool can now be cleaned.
Note:
If the heater is not used or is not used correctly, the
device cannot be switched on or operated.
Heaters plug in
www.gastrofrit.ch
© Switzerland Gastrofrit AG
13
