1.
Switch off the device, press the on / off button.
2. Open the drain cock (see Emptying) and drain the
water. There must be no contents (baskets, pasta
residues or cleaning water) in the cooking basin
3. Let the heating cool down to 35 ° C (hand warm).
4. Removal or insertion is easy, as shown in the
sketch. Without great force. Don‘t try to force it!
The whole
process takes place in a round, harmonious
movement (due to the design). Press the heater
lightly against the wall of the pan.
5. We recommend cleaning the heater in an appli-
ance dishwasher. To do this, the protective cap
supplied (item no. 501000-812) should be slipped
over the plug head.
6. In order to clean the interior, the cone plug (Art.
No. 305010.050) must be plugged into the heating
duct.
Please insert the cone plug in
advance!
7. Remove dirt with a brush. (Do not use a steel
brush or steel wool)
8. The interior is cleaned by boiling water with a
grease-dissolving cleaning agent in the device.
Rinse thoroughly and dry out.
9. Drain the dirty water from cleaning into the
empty collecting tank / sewer system.
10. Remove the plug again. Dry the wet power plug
well before using it again.
11. Place the heating element back in the device.
12. Filling: Only fill the water up to the maximum
water level.
13. The device is ready for the next use again! All
sheets are made of stainless steel and can be
treated with a commercially available chrome
steel cleaner.
Daily cleaning of the heater protects the device and
the performance of the heater is maintained.
Note:
If the heater is not inserted or not inserted correctly,
the device cannot be switched on.
DANGER:
After each cleaning, the white plug must be cleaned
of possible water droplets and dried out.
Hazard warnings
• Under no circumstances should the pasta cooker
be operated without water. If the level falls below
the lowest level, the device can be damaged!
• The heater must not be removed during opera-
tion.
• Entering too large amounts will increase the frot-
hing of the water and reduce the quality! Water
that is too starchy must be replaced.
• If the drying cycle is unintentionally caused, the
device cover must be used to control smoke. In
the event of a smoke incident, put the lid on the
basin immediately! Turn off the main switch and
pull out the power plug!
• There is a risk of splashing and burns!
• The power plug must be accessible at all times in
order to disconnect the machine from the power.
• If the connection cable is damaged, it must be
replaced by the manufacturer.
• This device is not intended to be used by persons
(including children) with limited physical, sensory
or mental capabilities due to lack of experience
and / or lack of knowledge. Unless they are super-
vised by someone responsible for your safety or
have received instructions from them on how to
use the device.
www.gastrofrit.ch
© Switzerland Gastrofrit AG
14
