44
jug with the blender jug placed on the motor base. Always switch OFF (turn ON/
OFF switch to ›0‹), wait until the blades come to a complete standstill and remove the
blender jug from the motor base, before opening the lid and taking out or checking
your food or pushing your food down in the blender jug. Only use cooking utensils
made of wood, rubber, or plastic with the appliance. Do not use violence, espe-
cially when removing obstacles blocking the blades to avoid damage to the blades.
Ensure to place the appliance on a level, flat, stable, and dry surface. Do not place
the appliance near the edge of the working space or on inclined surfaces. Take into
consideration that the appliance could move around due to vibrations during ope-
ration.
Always keep your workspace clean and dry during operation. Immediately wipe off
spilled liquids or splashes using a dry cloth. Do not place the motor base on wet or
moist surfaces or on any clothes. Do not let any liquids run under or on the motor
base. If any liquids ran into the motor base or run out during operation, immediate-
ly unplug the appliance (see: ‚Solving Problems‘). If in doubt, contact an authorised
service centre for examination (see also: ‘Solving Problems’).
Always remove the blender jug from the motor base, before filling the blender jug or
removing the lid.
Only place the blender jug on a clean, dry, stable and level sur-
face. Do not expose the blender jug to extreme temperature variations (e.g. pouring
hot water into the blender jug just after crushing ice).
The maximum temperature of
food and liquids filled into the blender jug is 60°C.
Always close the blender jug with
the lid and measuring cup before operation. Otherwise, liquids and splashes could
escape. Always ensure that the exterior of the blender jug is dry and clean, before
placing the blender jug onto the motor base.
CAUTION:
The appliance will not work without the blender jug on the motor
base. However, do not remove the blender jug from the motor base during operati-
on, to avoid damage to the drive wheel (in the motor base) and the coupling (in the
blade assembly). Always switch OFF (turn ON/OFF switch to ›0‹) and wait for the
blades to stop complete, before removing the blender jug from the motor base. To
avoid overheating, before operation, always fill a sufficient amount of food or liquid
into the blender jug (at least 200 ml). Do not fill in more than 800 ml to avoid over-
flow. Do not leave any food in the blender jug after use, to avoid that any residues
dry on the surfaces or go off within the blender jug (see: ‘Care and Cleaning’).
IMPORTANT:
If your Design Mixer Mini is still new, you may notice a burnt smell,
when starting the motor. This is no reason for concern and will vanish with repeated
use.
Summary of Contents for 40897
Page 59: ...59...
