Gason SR Series, Operator'S Manual

Page: 32 / 140

Assembly Instructions
Page 28
10/09
Final Pre-Delivery Check List
After the Air Seeder has been
assembled and the distribution system fitted
to the implement a final check should be
carried out before delivery.
Trailer General
1. All wheel nuts tight (refer page 17).
2. Front axle bolts tight (single castor only).
3. Check tyre pressures (refer pages 8-14)
4. Bins clean on inside, no loose items.
5. Implement
hitch system is fitted
correctly and all fasteners are tight.
6. Calibration tray fitted & scales tested.
Electrical System
1. Check cable routing is clear of corners
and that there is enough slack for
turning.
2. Check that the installation of the monitor
in the tractor is as per the specific
monitor’s operator’s manual.
Ground Drive Metering System
1. Check clutch operation.
2. Set the implement seeding width on the
2200 Surveillance monitor.
3. Check magnetic clutch bolt tight
(40Nm).
4. Check correct metering system fitted.
5. All bearings greased (meterbox and
drive system including the nose bearing
on the metershaft assembly).
6. Meterbox hatches fitted.
Ground Drive Metering System - Cont.
7. Metering system turns freely.
8. Variator adjustment operates.
9. Calibration handle fitted.
10. Metershaft handle fitted.
11. Calibration sample box fitted.
12. All sprockets are aligned and tightened.
VRT Hydraulic Drive Metering System
1. Inspect large aluminium connectors at
the breakaway points for damage.
2. Set the implement seeding width factor
on the monitor.
3. Check correct metering system fitted.
4. All bearings greased (including the nose
bearing on the metershaft assembly).
5. Meterbox hatches fitted.
6. Quick-change sprocket ratio handle
fitted.
7. Quick-change sprocket ratio shaft
screws are tight (use handle).
8. Calibration sample box fitted.
9. Prime metering system when the tractor
is connected to the seeder to test
electrical and hydraulic systems.
Distribution System
1. All retaining bolts are tight.
2. All hoses clear of moving parts.
3. Hoses do not sag or turn sharply.
4. Tertiary hoses have constant fall.
5. Hoses clear as wings fold.
6. All secondary head caps fitted.
7. All sowing boot fixings tight.