MDE-4813D CFN PLUS Installation Manual · February 2018
43
3
3
-
-
7
7
.
.
W
W
I
I
R
R
I
I
N
N
G
G
3-7.1. General
After completing the installation procedure, perform the following wiring procedures. The wiring is
performed in the CFN PLUS Terminal Block
only
.
The wires should be pulled from the conduits that protrude from the Installation Base, or in the
opposite direction, from the Terminal Block to the device in the Home Base Station.
3-7.2. Types of Wiring
The wiring in the Terminal Block differs in accordance with the type of pump installed in the Home
Base Station. There are two types of pumps:
•
Mechanical Pump
•
Electronic Pumps
The following paragraphs provide the wiring requirements for each type of pump.
3-7.3. Wiring Requirements
For any type of pump and wire, prior to inserting a wire, proceed as follows:
1.
Insert all wires with a terminal lug
only
.
2.
Use the proper Terminal Crimper to attach the lug to the wire.
3.
For UL Listing, the Terminal Lug must be a UL-recognized component.
Figure 3-9 Terminal Lug
T
T
I
I
P
P
Mark each cable at both ends with a number or sign
that will identify its functionality in the future.
3-7.4. Types of Cable
The following cables are required for the CFN PLUS installation:
•
Power cable - In accordance with local regulations
•
LAN cable – CAT-5E
