GAS GAS WILD HP 450-07, User Manual

Page: 109 / 142

When the fluid level is too low, fill up:
- With a cross-tip screwdriver, unscrew the two screws on the
recipient.
- Next, add liquid as required.
- Put the screws back in place and make sure the reservoir is tightly
secured.
Rear
FLUID LEVEL FOR REAR BRAKES
The pump is located on the lower right side of the vehicle, attached
to the rear brake pedal.
Check the brake fluid level through the spyhole
(A) . the presence
of bubbles means that the level has dropped, because of brake pad
wear or leakage.
- To replace or top up brake fluid, remove the two screws of the
upper cover and pull it upwards.
- Once the fluid is replaced, ensure that the cover is completely
closed.
Recommended liquid
Use D.O.T 3 or D.O.T 4
CHECKING THE FRONT AND REAR BRAKE PADS
There are 3 brake callipers: One on the each of the front wheels (2);
and 1 on the drive chain which brakes the rear wheels together. All
operate in the same way and are checked in the same way.
As we can see in the picture, the brake calliper is formed by different
parts. The pad is the part that rubs on the disk, thus, it is this element
that wears down and must be checked.
-
37
-
(C) Calliper
(D) Brake disk
(C)
(D)
(A)