BRAKE SYSTEM 12
83
J00084-10
–
Manually press the brake caliper toward the brake disc to push back
the brake piston. Ensure that brake fluid does not flow out of the
brake fluid reservoir; extract some if necessary.
Info
Make sure that you do not press the brake caliper against
the spokes when pushing back the brake piston.
–
Remove cotter pins
3
, pull out pin
4
, and remove the brake lin-
ings.
–
Clean the brake caliper and the brake caliper bracket.
J00085-10
–
Check that spring plate
5
in the brake caliper and brake pad slid-
ing plate
6
in the brake caliper bracket are seated correctly.
Info
The arrow on the spring plate points in the direction of rota-
tion of the brake disc.
J00088-10
–
Insert the new brake linings, insert pin
4
, and mount cotter
pins
3
.
Info
Always change the brake linings in pairs.
Make sure that decoupling plate
7
is mounted on the pis-
ton side brake lining.
–
Operate the foot brake lever repeatedly until the brake linings are in
contact with the brake disc and there is a pressure point.
I01082-10
–
Correct brake fluid level to marking
A
.
Brake fluid DOT 4 / DOT 5.1 (
–
Mount and tighten screw cap
1
with membrane
2
and the O-
ring.
Info
Use water to immediately clean up any brake fluid that has
overflowed or spilled.
