GAS GAS EC250 2012, Owner'S Manual

Page: 43 / 81

Owner’s manual
-43-
Transmission oil change
El aceite de transmisión debe cambiarse periódicamente para asegurar la vida
del motor.
1. Heat the engine for 5 minutes, in order to li ft all sediments.
2. Stop the engine and put a container under the motorcycle.
3. Remove the emptying screw (see “Checking the oil level”) and put the bike
in the use posi ti on to allow the complete oil drain.
4. Remove the fi ller plug to ensure a be tt er draining (3).
5. Clean perfectly the drain plug magnet.
6. Tighten the oil emptying screw with its o ring, at 20 Nm.
7. Take o ff the fi lling plug (see “Checking the oil level”) and put new trans-
mission oil.
8. Check the oil level, a ft er powering the kick-starter for 3 or 4 ti mes.
9. Screw the oil fi lling plug.
Maintenance
8.-PISTON AND RING
For this check, adjustment, or change, you must go to your GAS GAS o ffi cial
service.
9.-CYLINDER HEAD, CYLINDER, EX. VALVE
For this check, adjustment, or change, you must go to your GAS GAS o ffi cial
service.
10.-EXHAUST SYSTEM
Exhaust and mu ffl er reduces noise and lead gases away from the rider.
If the exhaust is damaged oxidized, beaten, or cracking, change it to a new one.
Change the silencer fi ber if the noise is becoming too high or the engine perfor-
mance decreases.
Exhaust cleaning
For the cleaning of the exhaust pipe you must go to your GAS GAS o ffi cial ser-
vice.
Mu ffl er change
1. Remove the bolt (1) of the le ft fairing.
2. Remove the bolt (2) of the mu ffl er (3) and take out by pulling backwards.
3. Disengage the mu ffl er (arrow) .
4. Change the mu ffl er and reassembly all parts.
3 1 2
3