Garmin GPSMAP 9000 Series, Owner'S Manual

Page: 69 / 232

Stopping Navigation
While navigating, from an applicable chart, select an option:
• Select Options > Stop Navigation.
• When navigating with Auto Guidance, select Options > Navigation Options > Stop Navigation.
• Select .
Waypoints
Waypoints are locations you record and store in the device. Waypoints can mark where you are, where you are
going, or where you have been. You can add details about the location, such as name, elevation, and depth.
Marking Your Present Location as a Waypoint
From any screen, select Mark.
Creating a Waypoint at a Different Location
1 From a chart, select Info > Waypoints > New Waypoint.
2 Select an option:
• To create the waypoint by entering position coordinates, select Enter Coordinates, and enter the
coordinates.
• To create the waypoint using a chart, select Use Chart, select the location, and select Create Waypoint.
• To create the waypoint using a range (distance) and bearing, select Enter Range/Bearing, and enter the
information.
Marking a Man Overboard or Other SOS Location
You must connect a VHF radio to the chartplotter before you can use the chartplotter to initiate SOS calls.
You can use the chartplotter to mark a man overboard or SOS location and immediately begin navigating to
the marked location. If you have a VHF radio connected to the chartplotter, you can also broadcast the SOS
information.
1 Select SOS.
2 Select Man Overboard or the SOS type.
3 If necessary, select Yes to navigate to the SOS location.
If you selected Yes, the chartplotter sets a direct course back to the location.
The call details are sent to the VHF radio. You must send the call using the radio.
Projecting a Waypoint
You can create a new waypoint by projecting the distance and bearing from a different location. This can be
helpful when creating sail racing start and finish lines.
1 Select Info > Waypoints > New Waypoint > Enter Range/Bearing.
2 If necessary, select a reference point on the chart.
3 Select Enter Range/Bearing.
4 Enter the distance, and select Done.
5 Enter the bearing, and select Done.
6 Select Create Waypoint.
Viewing a List of all Waypoints
Select an option:
• Select Info > Waypoints.
• From a chart or 3D chart view, select Options > Waypoints.
Navigation with a Chartplotter 55