Garmin GPSMAP 9000 Series, Owner'S Manual

Page: 154 / 232

Using the Bilge Pump Switches
You can manually operate connected bilge pumps by using switches 12 and 13 on the Garmin chartplotter.
1 From a Garmin chartplotter connected to the same NMEA 2000 network as the Garmin Boat Switch device,
select Vessel > Switching.
2 Select an option:
• Press and hold the bilge pump switch for one second to run the bilge pump for 2 minutes.
• Press and hold the bilge pump switch for three seconds to run the bilge pump continuously.
NOTE: Your Garmin chartplotter notifies you every 5 minutes while continuous mode is active.
Using Dimmable Lights
You can operate connected dimmable lights by using switches 17 through 21 on the Garmin chartplotter.
1 From a Garmin chartplotter connected to the same NMEA 2000 network as the Garmin Boat Switch device,
select Vessel > Switching.
2 Select an option:
• Press a dimmable light switch to turn a light on or off.
NOTE: The light turns on at the dim level set when the light was last turned off.
• With a light on, press and hold a dimmable light switch dim the light, and release to stop dimming.
• With a light off, press and hold a dimmable light switch to turn on the light at 100% brightness.
Controlling Third-Party Equipment Installed on Your Boat
Power-Pole
®
Anchor System
WARNING
Do not engage the Power-Pole Anchor System while underway. Doing so could cause result in an accident
causing property damage, serious personal injury, or death.
If a compatible Power-Pole anchor system is connected to the NMEA 2000 network, you can use the
chartplotter to control the Power-Pole anchor. The chartplotter automatically detects the Power-Pole anchor
system's C-Monster
® gateway on the NMEA 2000 network.
Enabling the Power-Pole Anchor Overlay
You must enable the Power-Pole overlay on the chartplotter to control the Power-Pole anchor.
1 From the page to which you will add the overlay, select Options > Edit Overlays.
TIP: To quickly select the overlay, select Toolbars > Anchor.
2 Select where you want to add the overlay.
3 Select Power-Pole® Anchor.
After you enable the Power-Pole overlay on the chartplotter, you must set the Power-Pole installation mode to
match the Power-Pole anchor installation on the boat (
Setting Up the Power-Pole Anchor, page 141 ).
140 Controlling Third-Party Equipment Installed on Your Boat