Garmin GPSMAP 9000 Series, Owner'S Manual

Page: 44 / 232

Turning On and Off the Remote Backlight
Turning off the remote backlight can significantly increase the battery life.
1 On the chartplotter, select Settings > Communications > Wireless Devices > Wireless Remotes > GPSMAP®
Remote > Backlight.
2 Follow the on-screen instructions.
Disconnecting the Remote Control from All Chartplotters
1 On the chartplotter, select Settings > Communications > Wireless Devices > Wireless Remotes > GPSMAP®
Remote > Disconnect All.
2 Follow the on-screen instructions.
Wireless Wind Sensor
Connecting a Wireless Sensor to the Chartplotter
You can view data from a compatible wireless sensor on the chartplotter.
1 Select Settings > Communications > Wireless Devices.
2 Select the wind sensor.
3 Select Enable.
The chartplotter begins searching for and connecting to the wireless sensor.
To view data from the sensor, add the data to a data field or gauge.
Adjusting the Wind Sensor Orientation
You should adjust this setting if the sensor does not face the front of the boat, exactly parallel to the center line.
NOTE: The opening where the cable connects to the pole indicates the front of the sensor.
1 Estimate the angle, in degrees clockwise around the mast, by which the sensor points away from the center
of the front of the boat:
• If the sensor is facing starboard, the angle should be between 1 and 180 degrees.
• If the sensor is facing port, the angle should be between -1 and -180 degrees.
2 Select Settings > Communications > Wireless Devices.
3 Select the wind sensor.
4 Select Wind Angle Offset.
5 Enter the angle observed in step 1.
6 Select Done.
Viewing Boat Data on a Garmin Watch
You can connect a compatible Garmin watch to a compatible chartplotter to view data from the chartplotter.
1 Bring the Garmin watch within range (3 m) of the chartplotter.
2 From the watch clock screen, select START > Boat Data > START.
NOTE: If you have already connected to a chartplotter, and would like to connect to a different chartplotter,
open the Boat Data screen, hold UP, and select Pair new.
3 On the chartplotter, select Settings > Communications > Wireless Devices > Connect IQ™ Apps > Boat Data >
Enable > New Connection.
The chartplotter begins searching for and connecting to the wearable device.
4 Compare the code shown on the chartplotter with the one shown on the watch.
5 If the codes match, select Yes to complete the pairing process.
After the devices are paired, they connect automatically when they are turned on and within range.
30 Communication with Wireless Devices