APPENDIX A
NavData Card Use
190
190-00356-00 Rev B
Appendix A
NavData Card Use
The Jeppesen NavData
®
card supplied with your
400W-series unit can be installed or removed when
the 400W-series unit is off. Insert the card with the
swing arm handle at the bottom and the label facing
to the left (see illustration right). If the NavData card
is not present when the unit is turned on, you will
receive a “No Jeppesen Aviation Database - Limited to
user defined waypoints” message on the
database con-
firmation page
. If the NavData card is removed during
operation, a “Data card removed-Unit will restart in 30
seconds” warning. The 400W-series unit will automat-
ically reinitialize even if the card is reinserted. You may
also reinitialize the unit manually by pressing
ENT
.
To insert the NavData card:
1. Place the card nto the NavData card slot, wth
the label facng to the left and the swng arm
handle at the bottom front.
NOTE:
There are two data card slots on the face
of the 400W-series. The Jeppesen NavData®
card should be inserted in the left-most slot. The
second slot is provided for the terrain card.
2. Press the NavData card nto place untl t seats
on the nternal connector and the front of the
card s flush wth the face of the 400W-seres
unt.
3. If the swng arm handle s up, gently lower the
handle and push t nto place—flush wth the
face of the 400W-seres unt.
To remove the NavData card:
1. Gently press on the tab—usng a slght upward
moton—at the front center of the NavData
card. Ths wll partally deploy the swng arm
handle.
2. Turn the swng arm handle upward (and out-
ward) untl t locks nto place, perpendcular to
the face of the 400W-seres unt.
3. Grasp the top and bottom surfaces of the swng
arm handle, between your thumb and forefin-
ger, and pull drectly away from the face of the
400W-seres unt to unseat the connector and
remove the NavData card.
190-00356-00_0B.indd 190
9/7/2007 2:50:09 PM
