![background image](http://html1.mh-extra.com/html/garland/sco-es-20s/sco-es-20s_installation-operation-and-maintenance-manual_3687286007.webp)
Part Number 4530589 rev B 4/15
7
INSTALLATION
Entry Clearance
•
Crated: 47” (1194mm)
•
Uncrated: 32-1/2” (826mm)
Installation Clearance
NOTE: Always provide adequate clearance for maintenance
and operation.
•
Installation adjacent to combustible and non-
combustible wall, minimum clearance:
Left Side
Control Side
Rear
Single-Deck
1" (26 mm)
1" (26 mm)
3" (77 mm)
Double-Deck
1" (26 mm)
2" (51 mm)
3" (77 mm)
•
Installation near high heat producing equipment,
minimum clearance:
Left Side
Control Side
Rear
Single-Deck
1" (26 mm)
6" (153 mm)
3" (77 mm)
Double-Deck
1" (26 mm)
6" (153 mm)
3" (77 mm)
Notice
Avoid installing ovens near equipment, such as char-
broilers or fryers, which generate high heat and high
grease laden air.
•
Clearance for Service (recommendation):
Control Side, minimum
Single-Deck
12" (305 mm)
Double-Deck
12" (305 mm)
NOTE: Install units with casters in very tight
locations for ease of service.
Installation Of Ovens Equipped With Casters
A. For an appliance equipped with casters, the installation
shall be made with a connector that complies with the
Standard for connectors for Movable Appliances, ANSI
Z21.69. Adequate means must be provided to limit the
movement of the appliance without depending on
connector wiring.
B. The front casters of the unit are equipped with brakes to
limit the movement of the oven without depending on
the connector wiring to limit the appliance movement.
C. The restraint can be attached to the unit near the
electrical inlet. If the restraint is disconnected, be sure to
reconnect the restraint after the oven has been returned
to its originally installed position.
Installation of Double Deck Models
A. Position insert in bottom leg opening and tap insert up
into leg until it seats at collar. Attach six inch (6”, 152mm)
legs to lower oven section. Raise unit or lay on its left side.
Place the front legs on the oven so as to line up with four
(4) attaching bolt holes. Secure leg to oven frame using
four (4) 3/8-16 x 3/4 bolts and washers provided. Repeat
at rear of unit.
B. Remove lower front cover of top deck (located under
oven doors). Raise top deck into place and line up body
sides and back of the unit. Fasten the rear of the units
together, with the stacking bracket, using (6) 1/4-20
machine screws, lock washers and nuts, (provided).
C. Install the interconnecting fl ue parts, carefully following
the instructions contained in the stacking kit. Pay
particular attention to the type of ovens you are stacking
and be sure to follow the corresponding instructions.
D. Check leveling of unit four (4) ways (using a common
carpenter’s level on the rack inside the oven).
E. Maintain clearance from combustibles.