SERVICE MANUAL
GARLAND CLAMSHELL GRILLS WITH PRODUCT RECOGNITION
PART #4526396 (03/30/10)
Page 40
In order to ensure that the platen reed switches are in
their proper location, you must ensure that the distance of
the magnet is the correct distance away from the switch
(located inside the upper platen).
1) Enter the “LEVEL/REED SW” Mode”
a) With the controller display ON and either
displaying the current menu item or displaying
“OFF”, PRESS and HOLD the button for
approximately 3 seconds. Controller will display
the previously selected menu item and its
corresponding item number OR “Standby /
Menu Item”.
b) PRESS the AND arrow buttons TOGETHER.
“CONFIGURE” will appear in the display.
c) PRESS the 2X. “CALIBRATION” will appear in the
display.
d) PRESS the button. “LEVEL/REED SW” will appear
in the display.
e) PRESS the button. “NO” will begin to flash.
f) PRESS the button. “NO” will change to “YES”.
g) PRESS the button. “YES” will stop flashing.
h) Ensure the grill surface is free of objects and
debris, then press the GREEN pushbutton to
lower the platen.
2) Using a flat screwdriver or the Platen Adjusting tool,
remove the platen adjuster grease caps.
3) Using a flat screwdriver or the Platen Adjusting tool,
Remove the platen adjuster locking caps.
4) Adjust Platen:
a) Using a flat screwdriver or
the Platen Adjusting tool,
adjust rear of platen until
the Gap Gauge fits snugly
between the upper platen
and grill surface. The Gap
Gauge should fit snugly
under the platen, but STOP
at the raised emboss on the
gapping tool (No-Go).
b) Move next to the front adjustment and raise or
lower the front of the upper platen until the Gap
Gauge fits snugly between the upper platen and
grill surface. The front of the platen has only a
SINGLE-POINT adjustment. Fit the Gap Gauge
under the front of the platen, and adjust until both
sides gauge equally.
5) After adjusting the upper platen, YOU MUST ADJUST
AND SET THE UPPER PLATEN REED SWITCHES. Proceed
to section titled “TO SET THE REED SWITCHES” on page
41.
PLATEN LEVELING (ZEROING)
PLATEN SIDE VIEW
GAP = .082”
GAP = .082”
PLATEN
GRILL PLATE
INSERT GAP
GAUGE HERE
FROM SIDE
INSERT GAP
GAUGE HERE
FROM FRONT
Platen Adjusting Tool
GAP�GAUGE�
PN�1838701
GO
INDEXING�
HOLE
NO�
GO
PN 4523323
Summary of Contents for MWE3S
Page 2: ......
