![background image](http://html1.mh-extra.com/html/garland/mco-gd-10ce/mco-gd-10ce_original-user-manual_3699721009.webp)
Part # 1955201 Rev.7 (11/28/12)
Page 9
Pressing the
COOL DOWN
key will deactivate the heat, turn
the fan on high and light its LED. The display will indicate
"OPEN DOOR"
if the door is closed, prompting the user to
open the door slightly. With the door open slightly the display
will indicate
"COOL"
. The Cool Down will operate when the
door is closed or opened
slightly
.
Optimal cool-down will be
achieved with the door open slightly .
When the door opens
wider, the Cool Down mode will deactivate and the display
will indicate
"DOOR"
.
This is a patented safety feature
. Pressing
the
COOL DOWN
key again will turn the LED off and stop this
mode. Pressing the
ON/OFF
key will also cancel Cool Down.
Cool Down is not active during a cook.
When the
ON/OFF
switch is pressed to turn the oven off and
the oven was above 200°F (93°C), the oven will go into an
Auto Cool Down
mode. In Auto Cool Down, the oven will
run the fan on high until the oven cavity drops below 150°F
(66°C). During this time the display will indicate
"AUTO"
.
When the oven temperature drops below 150°F (66°C) the
oven turns off.
This feature protects the oven motor from pre-
mature failure
.
Optimal cool-down will be achieved with the
door open slightly
.
Fahrenheit/Celsius
Factory default is Celsius (C). To change to Fahrenheit (F),
press and hold in the "Phantom Key" located to the right of
"
COOK/HOLD
" key. "C" appears in the display. Continue to
hold until "F" is displayed and then release the "Phantom key".
Operating the Controls
Setting the cook temperature and time are done in the same
manner. Pressing the
SET
key will light the
TEMP
LED
. The
operator then sets the temperature by rotating the dial on
the controller until the desired temperature is shown on the
display. Pressing the
SET
key a second time lights the
TIME
LED and allows the operator to select the desired cook time
as shown on the display. Pressing the
SET
key a third time
ends the programming.
Pressing the
START/CANCEL
key will start the timing cycle.
The display will count down from the Set time in minutes
and seconds (solid colon) or hours and minutes (blinking
colon) the minutes and seconds. When the cycle is completed,
processing this key will also cancel the "
DONE"
prompt. To
cancel a timing cycle in progress, press and hold the
START/
CANCEL
key for 3 seconds.
OPERATION Continued