12
NURSE button on IC2020.
During the Speech period, IC2020 will
emit two beeps via the telephone
handset to alert the call recipient the
remaining time of 20 & 10 sec.
During the Speech period, if there is
no any DTMF command pressed, the
call will automatically hang-up and be
recorded as an unsuccessful call. It
will retry a max of 4 times on each Tel.
Number accordingly.
Command 31
Ringer Enable for In-coming Calls
z
The IC2020 can be programmed to sound
a ring tone as an audio alert or operate
silent for an in-coming call:
Function Selection
Result
(0)
OFF
(Ring Tone Disable)
(1)
ON
(Ring Tone Enable)
z
Factory
Default
is set as
(0) OFF
.
<
<
N
N
O
O
T
T
E
E
>
>
)
If the function is set to
ON
, you can
answer the incoming call by pressing
the
RED EMERGENCY BUTTON
or
Pendant Button
.
)
The time-out period for the incoming
call is 30 minutes; during the
communication, the IC2020 will emit
two beeps via the telephone handset
to alert the call recipient the remaining
time of 20 & 10 sec. The duration of
this time-out period is unchangeable
and inextensible.
)
To terminate the incoming call: (1)
press the white NURSE button on
IC2020; or, (2) press DTMF #9 from
the call recipient’s end.
Command 32
Audible Fault Alert
z
The IC2020 can be programmed to sound
detected and existent Fault Alert Beeps
every 30 sec.
Function Selection
Result
(0)
OFF
(No Warning Beep)
(1)
ON
(With Warning Beep)
z
Factory Default
is
set as (
0
),
OFF
.
z
The fault situation includes Low Battery
Fault (for both IC2020 and Devices) and
AC Failure.
<
<
N
N
O
O
T
T
E
E
>
>
)
Battery back-up time will be shortened
if this function is turned on.
Command 33
Help Arrived Signaling
This function is only available for the digital
Contact ID reporting method.
z
It is used for the Monitoring Center
personnel to confirm if the help has arrived
for the user or not.
z
If Help Arrived Signaling is set to
ON
, once
the Alarm Reporting is completed, the
RED EMERGENCY BUTTON will start to
flash.
Press the White NURSE Button when the
Help arrives, and IC2020 will report to
monitoring center and the RED BUTTON
will stop flashing.
z
If Help Arrived Signaling is set to
OFF
,
once the Alarm Reporting is completed,
IC2020 will return to idle mode.
