8
Step 4.
You are now in
Programming Mode
.
Proceed to program by referring to
the Command in section
3.2
Programming Your IC2020
.
<
<
N
N
O
O
T
T
E
E
>
>
)
The first digit of Access Code must be
entered within 15 seconds, otherwise
the IC2020 will exit automatically.
)
Failure to enter the correct Access
Code within 2 minutes will cause
IC2020 to exit the Programming mode
automatically.
)
To exit Remote Programming mode,
enter
99
followed by
#
.
3.1.3. CTC-835 Programmer
CTC-835 is a powerful local & remote
handheld programming tool (sold separetely)
that features a built-in keypad and LCD display
to help you to program the medical alarm
panels effeciently and conveniently. It also
features
Once-for-All Uploading
, which
allows you program on a computer via the
supplied
Pilot
software and you can then
upload all the settings to the medical alarm
panel simultaneously with a single mouse click.
For detailed usages, please refer to the
Operation Manual of CTC-835 Programmer.
3.2. Programming Your
IC2020
z
How to enter Commands?
Please make sure IC2020 is in Programming
Mode (RED LED flashes continuously)
before trying any IC2020 Command
Functions. Please refer to section System
Configuration, Entering Programming Mode.
z
Follow the protocol below to command
the IC2020:
CC # DTMF
ACK
Function
Selection
# DTMF
ACK
1. 2. 3.
4.
5.
6.
1.
CC
= 2-digit DTMF Command
2.
#
=
Termination of the DTMF Command
3.
ACK
=
DTMF Command
Acknowledgement
from IC2020
Short beep: Command succeeded
Long beep: Command failed
4.
Function Selection
= According to
different Command you will have different
entering in this part, e.g. Tel. Number,
Account number, etc.
5.
# =
Terminates Function Selection
6.
ACK
= Function Selection
Acknowledgement
from IC2020
Short beep: Function Selection succeeded
Long beep: Function Selection failed
z
Follow the Command Steps to program
your IC2020:
Step 1.
Enter Command number (DTMF
Numeric Command, ex. (
01
), (
02
)…)
Step 2.
Press (
#
) to terminate the DTMF
Command.
Step 3.
One short beep will be heard for
successful Command entry.
Step 4.
Enter the desired Command function
number.
Step 5.
Enter (
#
) to terminate the Command
Operation.
Step 6.
IC2020 will emit a short beep,
indicating successful programming.
z
The maximum interval between key
strokes is 2 minutes.
Otherwise,
commands will be ignored and IC2020
will automatically exit to Idle Mode.
z
Any erroneous programming must be
rectified and program again correctly.
