TR-CL180 Lens Controller - User Manual
Add a step to the sequence
RX1,2,f,t
Where:
f
focal power in diopters
t
time at this step in milliseconds
Add a step to the sequence using the current focus
RX1,3,t
Where:
t
= time at this step in milliseconds
Status command
ST
An example of the information that could be returned on receipt of
an
ST
command is given below:
CH1,MD2, AF 0.00, IF 0.00,IP1,FL14
Analog profile: (1.00, -4.00), (1.90, -3.50),
(2.80, -3.20), (3.70, -2.00), (4.6
0, -1.50), (5.40, 1.50), (6.30, 2.00), (7.20,
3.20), (8.10, 3.50), (9.00, 4.00),
Waveform period 0.050s
No EEPROM range IF 0.00 XF 0.00, current IC
0.000 XC 0.000
Step sequence: (4.00, 0.10), (3.00, 0.20),
(2.00, 0.15), (1.00, 0.20), (0.00, 0.
30), (-1.00, 0.10), (-2.00, 0.20), (-3.00,
0.30), (-4.00, 0.15),
Note:
The
analog profile
lists the points entered using the RA
commands, and the
step sequence
lists the points entered using
the RX commands.
—
40
—
TR-CL180 Lens Controller - User Manual
14.8 Command summary
Command
Example
Effect
AW
AW
Save changes.
CL
CL
Clear configuration.
GT
GT1
Enable Ethernet messages.
GR
GR
Clear any error conditions.
EY
EY65,66
Set webpage password to 'AB'.
VR
VR
Read the firmware version.
RS
RS1,6.5
Set the lens to 6.5 diopters
continuously.
RA
RA1,0
RA1,1,4
Set the lens to analog control mode.
Set 4 points in the non-linear
translation profile.
RN
RN1,1,100
Set a continuous square wave at 10Hz.
RX
RX1,0,5
Set the sequence to 5 steps.
RU
RU1,4.3,-1.8
Set the lens to switch between 4.3
diopters when Trigger input is High and
-1.8 diopters when Trigger input is Low
KB
KB1,23
Disable the keypad buttons on the
front panel. Set the unlock code to 23.
ST
ST
Show the unit's configuration details.
—
41
—
WWW.STEMMER-IMAGING.COM
