TR-CL180 Lens Controller - User Manual
CH1
is displayed and the TR-CL180
keypad is unlocked.
If the code entered is incorrect,
LOC
is
displayed.
11.0.7 Viewing the output current
You can view an approximate measure of the output current from the
TR-CL180 front panel. The current measurement is updated roughly once
per second.
To view the output current, press and hold
SEL
for 1 second and follow the
keystrokes below:
CH1
is displayed, Press the
SEL
button.
Use the
p
and
q
buttons to scroll to
UAL
and press the
SEL
button.
The measured output current is
displayed. Press the
SEL
button.
Continue to use the TR-CL180 normally.
—
22
—
TR-CL180 Lens Controller - User Manual
12
Ethernet address
You may need to ask your network administrator for advice about setting
up the Ethernet connection.
The application note APP923 – Troubleshooting Ethernet problems is
available from
www.gardasoft.com/Downloads
.
The Ethernet set up of the TR-CL180 is not affected by cold-booting the
controller.
12.1 IP address
The TR-CL180 needs an Internet Protocol (IP) address to communicate
over Ethernet. There are two ways to get an IP address; either
programmed into the unit or using DHCP.
For DHCP mode, the TR-CL180 acquired its IP address, subnet mask,
and gateway address from the DHCP server. Otherwise the TR-CL180
has a fixed IP address, subnet mask, and gateway address.
DHCP mode or the IP address can be set or read using the
GardasoftMaint program available from
www.gardasoft.com/Downloads.
The GardasoftMaint window is shown below:
—
23
—
WWW.STEMMER-IMAGING.COM
