Ganz
Thermal
Series User Manual
28
5.2.1.2
Email Server
The camera can send you email notification on alarm but to do this it requires access to a
Simple Mail Transport Protocol (SMTP) server (to actually send the email). SMTP
Authentication is a means of using one's credentials to authenticate to an email server
with the intent of using that email server to send email.
Check the Enable Authentication box and enter the email username, email password,
email sender address, SMTP server IP address and email address in the respective
fields. You can send a test email by pressing the Send Test Email button. Make sure to
save the changes by pressing on the Save Changes button. Table 9 describes the fields
that are necessary to authenticate to an SMTP email server. Figure 32 illustrates a
completely filled out form.
Table 9: Email Server
Email
Server
Description
Enable
Authentication
Check this box if your SMTP server requires Authentication. As a general rule
most SMTP servers required authentication.
Username
The Username is the name that was used to set up the email server account.
Password
This is the password associated with the Username above.
Email Sender
Is your domain email address. This is the address used to send your Internet
email. This address will appear in the “From” portion of the email
SMTP Server
The SMTP server is the outgoing mail server through which you send your
outgoing mail. Since you are connected to your Internet Service Provider (ISP),
they know that you are a valid subscriber and allow your outgoing email to be
relayed to the destination.
Email To
This is the address used to receive your Internet email. This address will
appear in the “To” portion of the email
Figure 32: Email Settings