conditions. Gamma vacuum products are designed and manufactured to
provide protection against electrical and mechanical hazards for the
operator and the area surrounding the product.
2.
Installation procedures are for use by qualified, authorized personnel
who have experience working with 50 V or greater. To avoid personal
injury, do not perform any installation or service unless qualified to do so.
3.
There are no serviceable parts inside the controller power-supply, and
voltages as high as 7 kV may be present. Do not open the supply case
under any circumstances. In the event of the power
‑
supply requiring
attention, return it to Gamma Vacuum.
4.
Do not disconnect the high-voltage cable with the power on. After turning
the power off, allow at least one minute before disconnecting electrical
equipment.
5.
Do not operate the controller without a proper electrical ground or near
water. The controller may be damaged and its safety reduced if it is
operated outside of its specifications.
Page 10
900031_J
900031_J - Safety and compliance