Gaggenau EB333111, User Manual And Installation Instructions

Page: 12 / 56

en
Before using for the first time
12
Other accessories Order number
Fully extendable tele-
scopic pull-out rack BA018105
Wire rack, chrome-plated,
without opening, with feet BA038105
Heating element for bak-
ing stone and roaster BA058115
Baking stone, baking
stone supports and pizza
paddle BA058133
Note:
Order heating ele-
ment separately
Baking tray, enamelled,
30 mm deep BA028115
Pizza paddle, 2-part set BA020002
Cast aluminium roaster
GN2/3, height 165 mm,
non-stick GN340230
Note:
Order heating ele-
ment and pull-out system
separately
Rotary knob, black, 2-part
set BA090100
5.2 Locking function
The locking function prevents the accessories from tilt-
ing when they are pulled out.
The accessories must be inserted into the cooking
compartment correctly for the tilt protection to work
correctly.
5.3 Sliding accessories into the cooking
compartment
The accessories have a locking function. The accessor-
ies must always be inserted into the cooking compart-
ment the right way round for the tilt protection to work
properly.
ATTENTION!
The accessories may tip.
▶
Do not push the accessories between the shelf posi-
tions.
1.
When inserting the wire rack, ensure that the lug
is facing downwards.
2.
Ensure that the safety bar on the wire rack is loc-
ated at the rear and is facing upwards.
6 Before using for the first time
Configure the settings for initial start-up. Clean the ap-
pliance and accessories.
6.1 Initial use
Implement the settings for initial use before using your
appliance.
First read the information under safety →
Page 2 .
The appliance must be installed and connected.
After connecting the appliance to the power supply, the
GAGGENAU logo appears for approx. 30 seconds and
then the appliance displays the "Initial settings" menu.
You can configure your new appliance for initial use.
The "Initial settings" menu appears only after the appli-
ance has been connected to a power supply and
switched on for the first time, or if the appliance has
not been connected to a power supply for a number of
days.
You can change all of the settings in the basic settings
→
Page 24 .
Setting the language
Requirement:
The display shows the preset language.
1.
Use the rotary selector to select the required display
language.
2.
Press to confirm.
Setting the time format
Requirement:
The display shows the possible formats
24h and AM/PM. 24h is preset.
1.
Use the rotary selector to set the required format.
2.
Press to confirm.
Set the time
Requirement:
The display shows the time.
1.
Use the rotary selector to set the required time.
2.
Press to confirm.