INSTALLING BOWL LIGHT KIT (OPTIONAL)
1.
Remove switch housing screws and then remove bottom cap of switch
housing shell on fan.
2.
Locate two wires in the switch housing (white and blue labeled “ for light”).
Connect them to the light kit wire connectors (Fig. 12-2)
3.
White to white
4.
Blue to blue
5.
Secure those wires with wire nuts in the fan.
6.
Carefully push all wires back into the switch housing. Then attach housing
cover plate to switch housing with the 3 screws provided.
7.
Attach the glass shades to the light kit, using 3 thumbscrews per shade
(provided). Do not over-tighten the thumbscrews as glass may break. Install
(60 watt max). Light bulbs (not provided).
8.
Slide the bowl glass over the threaded nipple, followed by the cap, and then
finial. Twist finial clockwise until snug (see figure (Fig. 12-2)
9.
Lower chains thru hole in bowl and glass cap.
10.
Attach chain extension (see figure 12-3)
11.
Restore power and your light kit is ready for operation.
If the light kit does not work, turn off the electricity and lower the canopy on your
ceiling fan. Make sure the blue wire is connected to black household wires
(please refer to electrical connections section in this manual).
Page 15