INSTALLING DISC BOWL LIGHT KIT(OPTIONAL)
1.
Remove switch housing screws and then remove bottom cap of switch
housing shell on fan.
2.
Locate two wires in the switch housing (white and blue labeled “ for light”).
Connect them to the light kit wire connectors
White to white
Blue to blue
Secure those wires with wire nuts in the fan.
3.
Carefully push all wires back into the switch housing. Then attach housing
cover plate to switch housing with the 3 screws provided.
Wire Nut
Screw/Washers
4.
Install light bulbs, (60 watt max), to the lampholder. . Light bulbs (not
provided).
Pull Chain Extension
Threaded Tube
5.
Attach the glass shades to the light kit, and screw up the finial. Do not
over-tighten the finial, glass may break. Slide the bowl glass over the
threaded nipple, followed by the cap, and then finial. Twist finial clockwise
until snug (see figure
Finial
Metal Cap
Glass Shade
6.
Lower chains thru hole in bowl and glass cap.
7.
Attach chain extension
8.
Restore power and your light kit is ready for operation.
9.
If the light kit does not work, turn off the electricity and lower the canopy on
your ceiling fan. Make sure the blue wire is connected to black household
wires (please refer to electrical connections section in this manual).
Page 13
