GAELCO Ring Riders, Operator'S Manual

Page: 38 / 95

GAELCO - RING RIDERS
38
If the micro-switch is faulty and needs to be replaced, ensure
that the common wire is connected to the square terminal
while the other wire is connected to the NORMALLY CLOSED
terminal (NC). This terminal is the one closest to the square
terminal.
5. Lift the cable from the plastic cupola by pulling it upwards.
6. Fit the new cable by following the reverse procedure. First thread the cable into the
cupola from the top. Then follow the steps below:
•
Fit the end of the cable in the switch lever.
•
Fit the tensor. Do not tight the nuts yet.
•
Fit the other end of the cable to the brake handle.
•
Adjust the tensor. The cable should be taut, but the lever must touch the stopper when
the brake handle is released. Tight the nuts of the tensor.
•
Fit the steering assembly into the chassis. Do not forget to connect the wires.
•
Fit the pastic covers.
•
Fit the cupola.
•
Fit back the rubber protection of the brake handle.
•
Ensure that the brake is working properly, as well as the rest of controls related to the
steering assembly (accelerator, steering motor, etc.). All these controls can be tested
from the
Input / Output of Test Mode.
9.4.3 REPLACEMENT OF THE BRAKE MICRO-SWITCH
4. Loosen the nuts that hold the cable tensor to the mechanism, using two spans of 12mm.
Then release the cable.