9
NOTE: The laser beam will be turned
off after the measurement is
complete.
The measurement reading can be
displayed either in Meters (m) or
Feet and Inches (ft+in). To change
between the Unit of measurement
press and hold the On/Off button for
two seconds.
taKIng an addItIonal
MeaSureMent
The unit is capable storing two
measurements at a time. To take a
second measurement press the
On/Off button. Point the laser beam
to the target surface. Keep the dot
on the target point. Press the On/Off
button again to take the
measurement. The measurement
value will be displayed immediately.
The latest measurement will always
be shown at the bottom of the LCD
display. (See LCD DISPLAY).
MaIntenance
general MaIntenance
This instrument is designed to
provide years of dependable service,
if the following care instructions are
performed:
Keep the laser measurer dry and
free from dust.
Use and store the laser measurer in
nominal temperature conditions.
Temperature extremes can shorten
the life of the electronic parts and
distort or melt plastic parts.
Handle the laser measurer carefully
and avoid shock and vibration.
Dropping the meter may damage the
electronic parts or the case.
Keep the laser measurer clean. Wipe
the case occasionally with a damp
cloth. DO NOT use chemicals,
cleaning solvents, or detergents.
Use only fresh batteries of the
correct type.
Remove old or weak batteries so
they do not leak and damage the
unit.
If the laser measurer is to be stored
for long periods, the batteries should
be stored separately to prevent
damage to the unit.
trouBleShootIng
code
cauSe & correctIVe
actIon
204
Calculation error. Repeat
the procedures in
‘OPERATION’.
208
Excessive current. Please
contact your distributor.
220
Battery low. Replace
batteries.
