Page 13 of 17 // Installation Instructions - EAD3
Mechanism Emergency Stop Connector
This mechanism features an Emergency Stop Connector, which MUST be plugged into the control box in the
connector labelled above for the mechanism to operate. If this connector is not plugged in, the Input Confi rmation
LED will be permanently lit. As per the red plastic tag attached to the Emergency Stop Connector (and shown
below), the small loop of wire in this connector is designed to be replaced by a third party safety mechanism.
Replacing Mechanism Batteries
The standard Future Automation Infrared (IR) remote control required x2 AAA batteries to operate. These are
provided with the mechanism in the Accessories Pack. These batteries can be replaced as the per the image
below.
Control Box Inputs
Mains Voltage Input
Input Confi rmation LED
IR Input Jack (3.5mm)
Emergency Stop Connector
Contact Closure (RJ45)
RS232 (RJ11/RJ25)
Mechanism Control
1 - General
This mechanism has multiple standard control methods, each of which requires a diff erent input method to the
control box. For ease, the input sockets on the control board are labelled below.
(Control box size and style may vary to image shown)
