95
＜
Linkage Menu
＞
HELI
COPTER
AIRPLANE
GLIDER
●To Swash
(AFR) screen
●Touch the [Swash] button in the Linkage Menu to call the
setup screen shown below.
Swash
Swash operation linkage correction function
(This swash setup screen does not appear for swash
type H-1.)
Neutral Point
On your linkages, if the servo horn deviates from
perpendicular at neutral, the linkage compensation
functions may not work effectively. This neutral point
setting reads the linkage compensation neutral position.
However, this adjustment only changes the reference
point of the compensation function on the swash details
screen and does not affect the neutral position of other
functions.
*Before using the compensation function, set the neutral
point.
Swash AFR
The swash AFR function adjusts (increases/decreases/
reverse) the rate (travel) of the aileron, elevator, and pitch
functions.
Mixing Rate
(Normally, the default value is used.)
This mixing rate is used for minor correction to the
swash plate so that it moves in the correct direction for
aileron, elevator, and pitch operation.
Compensation mixing is shown below.
*PIT
→
AIL/PIT
→
ELE/AIL
→
PIT/ELE
→
AIL/
ELE
→
PIT
*Use the corresponding compensation mixing and adjust so
that the swash plate moves in the correct direction
.
Linkage Compensation
This compensation mixing is used to adjust for
interference when the ailerons or elevators are operated
when the throttle stick was in the low or high position.
Speed Compensation
This speed compensation function make adjustments for
interference when the travel of each servo is different due
to swash plate operation. For HR-3, it compensates the
speed by dropping the operating speed of the aileron and
pitch servos during elevator operation.
●To Swash
Details screen
●Return to Linkage Menu
●Return to Linkage Menu
