FUTABA 32MZ, Instruction Manual

Page: 84 / 99

84 ＜
Linkage Menu
＞
HELI
COPTER
AIRPLANE
GLIDER
WARNING
Do not perform the linking operation when the
drive motor is connected and the engine was
started.
■
Inadvertent rotation of the motor or acceleration of the engine
is extremely dangerous.
Once the link operation is complete, please
check that your receiver can be operated with
the linked transmitter.
C
heck operation suficiently before lying after
linking.
■
If the same receiver is sending in the vicinity, there is the
danger that the transmitter may be linked with that receiver.
CAUTION
Always turn on the transmitter power after
linking is complete.
When pairing with the transmitter, be sure
that a previously linked transmitter is not
transmitting
Linking method (T32MZ ↔ R7108SB)
1. Bring the receiver to be linked to within 50 cm of
the transmitter.
2. Press the [Link] button in the [Link] box of [System
Type].
3. The transmitter emits a chime sound and enters the
link mode.
4. The receiver power is immediately turned on.
About 2 seconds after the power is turned on the
receiver enters the linking state.
(Receiver linking time is about 1 second)
5. If linking is successful, the receiver LED changes
from red to green, the link mode ends, and the
receiver ID code is displayed.
6. If linking fails, an error message is displayed. Bring
the transmitter closer to the receiver and repeat
the procedure above from step 2.
* Do not perform the linking operation when
the drive motor is connected or the engine is
running.
* When you use two receivers, please be sure to
setup a "primary" and "secondary" in the "dual"
mode.
* Since two sets of receivers cannot be
individually recognized without using a "primary"
and "secondary" setup, it is impossible to receive
telemetry data correctly.
* You must link one receiver at a time. If both
power supplies to the receivers are switched on
simultaneously, data is received incorrectly by
the transmitter.
* A telemetry function cannot be used for the 2nd
receiver.
* You cannot link three sets of receivers.
* Link is required when a system type is changed.
* Link is required when a new model is made from
a model selection.
● Touch the [Link] button in the System Type Menu to call
the setup screen shown below.
● Battery fail-safe voltage setup (only
FASSTest/T-FHSS mode)
●Return to System Type
Menu