87
＜
Linkage Menu
＞
HELI
COPTER
AIRPLANE
GLIDER
(The display screen is an example. The screen depends on the model type.)
Trim change
1. Touch the trim button to call the trim setup screen.
2. The following items can be set at the trim setup
screen.
● Hardware setting (Selection of switch, etc. which
controls trim) (The select screen is selected by
touching the [H/W Select] button.)
● Rate setting
● Operation step setting
● Trim mode setting
Normal mode: Normal trim (linear) operation
ATL mode: ATL operation mode. (Works at only one
end of operation) Reverse is also possible.
SWAP
If [SWAP] is pushed, it will call up the following
screen. You can easily change two separate
functions, keeping the data that was set for each
channel.
1. Select the (Trim) button for the two functions you
selected to Swap to set up the trims appropriately.
2. If [OK] is pushed, two channels will interchange.
*It can choose only to two.
CTRM mode: Maximum change near center by
center trim operation (Does not change at end of
the stick movement)
● Separate/combination mode: Trim data can be set
to different light conditions
Separate mode: Trim adjustment for each separate
light condition.
