135
<Model Menu (Airplane/Glider Functions)>
● Select the function name
and return to the Model
menu by touching the
R T N
b u t t o n .
O r t h e
H O M E / E X I T
b u t t o n i s
pushed.
<SensorTouch™>
RETURN
AIRBRAKE
[Corresponding model type]: Airplane, 2 ailerons or more
This function is used to increase the aircraft's
drag and is useful for landing or diving, etc.
The preset elevators and flaps (camber flap,
brake flap) offset amount can be activated by a
switch.
The offset amount of the aileron, elevator, and
flap servos can be adjusted as needed. Also the
speed of the aileron, elevator, and flap servos can
be adjusted. If the Auto Mode is activated, this
will link the Airbrake to a stick, switch, or dial. A
separate stick switch or dial can also be set as the
ON/OFF switch.
Setting example for F3A and other flaperon specifications
(When 2 ailerons model type selected)
Offset rate:
AIL: [-35~-45%], AIL2: [-35~-45%], ELE: [+5~7%]
Note: The input numerics are examples. Adjust the travel to
match the aircraft.
Mode setting:
ACT: [ON]
Switch: [SW-C]
AUTO-SW: [--]
● Select [AIRBRAKE] at the Model menu and access
the setup screen shown below by touching the
RTN button.
*The display screen is an example. The
actual screen depends on the model type.
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To next page
● Ailerons, flaps, and
elevators servo speed
setting
●Auto switch selection
● A i l e r o n s , f l a p s , a n d
elevators offset rate
● S w i t c h
selection