137
<Model Menu (Airplane/Glider Functions)>
● Select the function name
and return to the Model
menu by touching the
R T N
b u t t o n .
O r t h e
H O M E / E X I T
b u t t o n i s
pushed.
<SensorTouch™>
RETURN
GYRO
[Corresponding model type]: Airplane/glider, general
This function is used when a GYA Series gyro
is used to stabilize the aircraft's attitude. The
sensitivity and operation mode (Normal mode/
AVCS mode) can be changed via a switch.
● Three rates (Rate 1/Rate 2/Rate 3) can be
switched.
● Up to 3 axes (Gyro/Gyro 2/Gyro 3) can be
simultaneously controlled.
Note: This setting does not assign a sensitivity
channel. To do so, use the Linkage menu
prior to assigning the sensitivity channel
(Gyro/Gyro2/Gyro3), be sure to select an
unused channel.
Set the [Control] and [Trim] settings other than
Function to [--].
● The operation mode (AVCS/NOR)
and sensitivity of the three axis
Gyro/Gyro2/Gyro3 can be set.
● Select [GYRO] at the Model menu and
access the setup screen shown below
by touching the RTN button.
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To next page
(Active rate # display)
● Gyro type
selection
● ACT/INH
● Switch selection
● R a t e 1 - 3 s e t u p
screen selection
[Rate 1 setup screen]
[Rate 2 setup screen]
[Rate 3 setup screen]
Setting method
*Prior to using the Function menu in the Linkage menu to
assign the sensitivity channel (Gyro/Gyro2/Gyro3) select an
unused channel.
Set [Control] and [Trim] other than function to [--].
●Rate1-3 setup screen selection
Move the cursor to the setup screen selection
item and touch the RTN button to switch
to the data input mode. Select the setup
screen # by scrolling the touch sensor.
Touch the RTN button to change the setup
screen and return to the cursor mode.
●Activate the function
Move the cursor to the [INH] item and touch
the RTN button to switch to the data input
mode. Select the ACT mode by scrolling the
touch sensor.
*The display blinks.
Touch the RTN button to activate the
function and return to the cursor mode.
