133
<Model Menu (Airplane/Glider Functions)>
● Select the function name
and return to the Model
menu by touching the
R T N
b u t t o n .
O r t h e
H O M E / E X I T
b u t t o n i s
pushed.
<SensorTouch™>
RETURN
TRIM MIX
[Corresponding model type]: Glider, 2 ailerons or more
This function adjusts the trim offset rates of the
ailerons, elevators, and flaps (camber flaps, brake
flaps) according to the flight status.
As an example this function can be set up for
launching, with speed flaps and ailerons drooped,
and a slight amount of up elevator, and can be
used for high speed flying, with both ailerons and
speed flaps reflexed slightly, and a bit of down
elevator.
To prevent sudden trim changes when switching
flight conditions, a delay can be set to provide a
● Select [TRIM MIX] at the Model menu
and access the setup screen shown
below by touching the RTN button.
*The display screen is an example. The actual
screen depends on the model type.
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To next page
smooth transition between the two conditions. It
is also possible to program a cut switch which
will turn off the delay.
Furthermore, you can set the auto switch, which
will link the trim mix to a stick, switch, or dial.
Additionally, the speed of the aileron, elevator,
and flap servos can be adjusted.
(Currently selected condition name)
● Condition delay
setting
● Ailerons, flaps, and
elevators servo speed
setting
●Auto switch selection
● A i l e r o n s , f l a p s , a n d
elevators offset rate
● S w i t c h
selection
