149
<Functions of Model Menu (Helicopter Functions)>
Normal Curve
Idle-up 1 Curve
Idle-up 2 Curve
Hold Curve
●Pitch Curve (Example)
The screens shown below are curves created by
entering the pitch rate at low, center, and high side (3
points or 5 points) at each condition.
When actually creating a curve, input the rate
specified by the model (or the reference value).
Curve setting examples
Pitch Trim (Hovering pitch, high pitch, low pitch)
[Hovering pitch trim setting]
Hovering pitch trim
The Hovering Pitch trim function trims the pitch
near the hovering point. Normally, it is used with
the hovering condition. The hovering pitch can be
fine tuned for changes in rotor speed accompanying
changes in temperature, humidity, and other flight
conditions. Adjust the hovering pitch so that
rotor speed is constant. This function can be used
together with the Hovering Throttle Trim function
for more precise operation.
Setting method
● Set the function to ACT [ON]. (initial setting)
● Select the adjustment knob.
Selection example: LD (initial setting)
● The trim operation mode (Mode: CTRM/
NORM) can be selected.
CTRM mode:
Maximum amount of change
near center by center trim operation
(recommended)
N O R M m o d e :
N o r m a l t r i m ( p a r a l l e l
movement trim) operation. The advantage
of using this mode is that the hovering pitch
can be adjusted without changing the
curve.
● The trim rate can be adjusted and the
operation direction can be changed.
● Trim adjustment range (Range) setting
When this value is made small, trim can only
be used near the center.
