82
<Functions of Linkage Menu>
● Select the function name
and return to the Linkage
menu by touching the
R T N
b u t t o n .
O r t h e
H O M E / E X I T
b u t t o n i s
pushed.
<SensorTouch™>
RETURN
SERVO SPEED
Sets the speed of each servo.
The speed of the servo from 1CH to 12CH of
operation can be set up.
It can adjust to 0-27.
Speed becomes slow as a numerical value's 0
increases in the state of the fastest of the servo.
* Speed cannot be made quicker than the maximal rate of the
servo to be used.
Servo speed setting
1. Touch the Speed button of the channel you
want to set.
2. Use the adjustment buttons to adjust the
servo speed.
●Initial value: 0
●Adjustment range: 0~27 (steps)
*When the RTN button is touched for one second, the rate is
reset to the initial value.
3. Repeat this procedure for each channel.
* It will overlap, if speed control of a S.BUS servo setup is
used at the time of S.BUS servo use, and speed changes.
Please use one either.
* The speed of THR is not set up simultaneously with THR
DELAY (model menu : only airplane).
● Select [SERVO SPEED] in the Linkage menu and
access the setup screen shown below by touching
the RTN button.
(The display screen is an example. The
screen depends on the model type.)
Scrolling
● Moving cursor
● Adjusting value
● To next page
(channel)
(speed)
(speed)
(channel)
