Furuno GS-100, Operator'S Manual

Page: 58 / 157

6. BERTHING DISPLAY
6-4
6.3 Various Settings
Key beep
A key beeps when it is pressed. You can turn this beep
on or off.
1. Press the MENU ESC key to open the menu.
2. Select [Key Beep] then press the ENT key.
3. Select [ON] or [OFF] then press the ENT key.
4. Press the DISP key to close the menu.
Key dimmer
You can adjust the dimmer for the keys as follows:
1. Press the MENU ESC key to open the menu.
2. Select [Key BRILL] then press the ENT key.
3. Select a dimmer level (setting range: 1 to 8) then
press the ENT key. The higher the figure, the higher
the dimmer level.
4. Press the DISP key to close the menu.
How to change units of measurement
The UNIT key selects the unit of measurement for current (tide) speed, depth, dis-
tance, Doppler SOG and STW, GNSS SOG, and wind speed.
1. Press the UNIT key. A unit is highlighted in yellow.
2. Press the DISP key to select the data for which to change its unit. (Use the MENU
ESC key to reverse the selection order.)
3. Press the UNIT key to change the unit. See the table below for item and available
units.
To quit the unit selection, press the DISP key until the yellow highlight disappears.
Item Available units
Berthing display range meters/DIV (m/DIV), nautical miles/DIV (NM/DIV)
Ground tracking (SOG)
Water tracking (STW) kilometers/hour (km/h), knots (kn), meters/second (m/s)