Furuno CSH-5LMARK-2, Installation Manual

Page: 11 / 86

1. MOUNTING
1-3
Note: When the retraction tank is made locally, fin-
ish it so that the welding bead does not protrude on
the inner surface of the tank. The tank guide will hit
the bead, causing motor burn-out. The gap between
the tank and tank guide is 1 mm. Also when install-
ing the tank, orient the welding bead so it faces the
port or starboard side.
1.1.2 Installation of retraction tank
The retraction tank is 1000 mm in length when supplied. Cut the end of the tank refer-
ring to the table below so that the transducer is fully protruded beyond the keel when
it is lowered. Refer to the tank installation method at the end of this manual.
Welding Bead
Tank guide
Bow
Welding Bead
Tank Installation Method
Tank Cutting
When the length of tank is
1000 mm:
750 mm
(600 travel, shaft length 1300)
550mm
(400 travel, shaft length 945)
When the length of tank is
1000 mm:
750 mm
(600 travel, shaft length 1300)
550mm
(400 travel, shaft length 945)
C u t a l o n g t h e h u l l b o t t o m .
Cut
Note: It is not necessary to cut the shaft when there is enough space
above the raise/lower drive assembly.
Cut
Cutting the end of retraction tank