Further Tech Net-TV Box, User Manual

Page: 13 / 116

Introduction
W X
13
Rear Panel
RESET
： Press and hold for 3 seconds, the green led and the red led both blink three times at the same time
(blinking one time per second), then the box has been reset to factory defaults. If the power is off suddenly
before the leds blink, the [RESET]
won’t take effect, but you can start your box. If the power is off suddenly
when the leds are blinking, the [RESET] has been effective, after finishing the [RESET], the box will proceed
to [Power on] and [Starting]. (
Caution: The use of this button will result in the loss of existing
configuration. Maybe you should reset the network configuration of Box to connect to internet.
)
TUNER:
IN
：
It connects the CATV cable to receive the TV RF signals. OUT
：
It connects the RF IN of
your TV set via the enclosed Coaxial Cable to loop through the TV RF signals.