Full Vision TRACK MASTER FVX328, Owner'S Manual

Page: 28 / 79

Preventive Maintenance TRACKMASTER
6-4
FVX328 Series Owner’s Manual May, 2008
Check the belt after 2 minutes, with the treadmill running at approximately 7 mph. If the
belt does not correct itself, continue with slight turns until the belt is in the center of the
rear roller. If the belt runs toward the left, use the left adjustment.
Note:
Uneven floors accelerate belt misalignment. This situation may require either (1)
larger and more frequent adjustments to prevent belt damage, or (2) the installation of a
rubber treadmill pad, which is available at your local fitness store.
Running Belt Tension Adjustment
The running belt may stretch and loosen with regular use. This looseness is noticeable when the belt
tends to hesitate or stick. If the belt is loose and slipping, see illustration below.
1. Turn the treadmill’s power switch to ON.
2. Start treadmill and increase to 1 mph
3. Start walking on the treadmill, grab handrail and apply pressure with your foot to create
resistance on running belt.
4. If running belt slips on front drive roller, tighten both tension bolts ½ turn (Clockwise).
5. Repeat steps 2 thru 4 until running belt stops slipping.
Note: When running belt is too tight the edge of belt will curl causing premature
running belt failure.