Full Boar SD2200i, Instruction Manual

Page: 14 / 30

1
4
KNOW YOUR PRODUCT
Preparing to start
Note.
Before starting the engine, disconnect all appliances
from the generator.
1.
Set the
OFF/RUN/CHOKE SW.
(6) to the
“
CHOKE
”
position (Fig. 12).
OPERATION
OFF
REMOTE CONTROL
12V DC 8.3A
12 V APPLIANCE OUTLET 8.3A
5V DC USB
BATTERY POWER
OVERLOAD RUN LOW OIL
STOP
ECONOMY
ON
ON OFF
240V
OFF
STOP
START
ON
DC OVERLOAD
RESET
ON
STOP
START
ON
STOP
START
REMOTE CONTROL
ON
OFF
REMOTE CONTROL
12V DC 8.3A
12 V APPLIANCE OUTLET 8.3A
5V DC USB
BATTERY POWER
OVERLOAD RUN LOW OIL
STOP
ECONOMY
ON
ON
OFF
240V
OFF
STOP
START
ON
Fig. 12
Fig. 1 4
Fig. 1 3
2 .
Hold the carrying handle firmly with one hand. With the
other hand, pull slightly on the rip cord (5) until you feel
resistance and then pull hard and
swiftly on the cord (Fig. 13). Do not let the rip cord retract
by itself, guide it back by hand.
3.
After the engine starts, allow it to run for a short period
of time to warm up,rotate OFF/RUN/CHOKE switch to RUN.
choke operation is reduced as OFF/RUN/CHOKE switch is
rotated towards RUN.
• Ground terminal connects the earth line for prevention of electrocution.
• Must keep the generator grounded while the electric device is grounded.
WARNING!
Fig. 1
5