Full Boar SD2200i, Instruction Manual

Page: 16 / 30

1
6
OPERATION (cont.)
OVERLOAD RUN LOW OIL
240V AC
USB
12V DC 8.3A
BATTERY CHARGE
REMOTE
CONTROL
STOP
ECON
12V APPLIANCE OUTLET 8.3A
ON OFF
ON
ON
START
OFF
ON
OFF
5V DC USB
USB
12V DC 8.3A
BATTERY CHARGE
REMOTE
CONTROL
STOP
ECON
12V APPLIANCE OUTLET 8.3A
ON OFF
ON
ON
START
OFF
ON
OFF
5V DC USB
OVERLOAD RUN LOW OIL
240V AC
USB
12V DC 8.3A
BATTERY CHARGE
REMOTE
CONTROL
STOP
ECON
12V APPLIANCE OUTLET 8.3A
ON OFF
ON
ON
START
OFF
ON
OFF
5V DC USB
USB
12V DC 8.3A
BATTERY CHARGE
REMOTE
CONTROL
STOP
ECON
12V APPLIANCE OUTLET 8.3A
ON OFF
ON
ON
START
OFF
ON
OFF
5V DC USB
OVERLOAD RUN LOW OIL
240V AC
USB
12V DC 8.3A
BATTERY CHARGE
REMOTE
CONTROL
STOP
ECON
12V APPLIANCE OUTLET 8.3A
ON OFF
ON
ON
START
OFF
ON
OFF
5V DC USB
OVERLOAD RUN LOW OIL
240V AC
USB
12V DC 8.3A
BATTERY CHARGE
REMOTE
CONTROL
STOP
ECON
12V APPLIANCE OUTLET 8.3A
ON OFF
ON
ON
START
OFF
ON
OFF
5V DC USB
OVERLOAD RUN LOW OIL
240V AC
USB
12V DC 8.3A
BATTERY CHARGE
REMOTE
CONTROL
STOP
ECON
12V APPLIANCE OUTLET 8.3A
ON OFF
ON
ON
START
OFF
ON
OFF
5V DC USB
OVERLOAD RUN LOW OIL
240V AC
USB
12V DC 8.3A
BATTERY CHARGE
REMOTE
CONTROL
STOP
ECON
12V APPLIANCE OUTLET 8.3A
ON OFF
ON
ON
START
OFF
ON
OFF
5V DC USB
USB
12V DC 8.3A
BATTERY CHARGE
REMOTE
CONTROL
STOP
ECON
12V APPLIANCE OUTLET 8.3A
ON OFF
ON
ON
START
OFF
ON
OFF
5V DC USB
AC Pilot Indicator Light
The green AC Pilot Indicator Light comes on when
the engine starts and generates power.
Oil Warning
Indicator
Overload
Indicator
AC Pilot
Indicator
Engine Overload Indicator Light
If the engine overload indicator light comes on, the generator
s wattage , / amperage capacity has been exceeded by
connected electrical devices or by a power surge. When this
occurs, the green AC Pilot Indicator Light will go off. The
engine will continue to run, but the red Engine Overload
Indicator Light will stay on and power will no longer be
supplied to connected electronic devices.
How to Correct
1.Disconnect any electronic devices then stop the engine.
2.Reduce the total wattage of connected electronic devices
until it is within the generator’s rated output.
3.Inspect the Air Inlet and Control Panel for any blockage.
Oil Warning
Indicator
Overload
Indicator
AC Pilot
Indicator
Remove blockage if found.
4.Restart Engine.
Note
: The engine overload indicator light may turn on for
a few seconds when attaching a load due to a power
surge. This is normal.
Oil Warning Indicator Light
When the oil falls below the minimum level, the oil warning
indicator light comes on and the engine stops
automatically. The engine will not restart until engine oil
has been filled to the correct level (refer to FIG 6)
Note
: If the oil warning indicator light does not come on and
the engine stalls, turn the Start Switch to “ON” and pull the
recoil starter.
Oil Warning
Indicator
Overload
Indicator
AC Pilot
Indicator