1
2
KNOW YOUR PRODUCT
Checking the oil
1.
Be sure to check that the generator is on a level surface with the engine stopped.
2.
To check the oil level, first loosen the 2 cover screws and
remove the rear maintenance cover (7) (Fig. 4).
3.
Remove the oil filler cap, and wipe the dipstick with a
clean rag. Check the oil level by inserting the dipstick in
the filler hole without
screwing it in and then removing it again (Fig. 5).
4.
If the oil level is below the end of the dipstick, refill using
oil fill bottle (10) until it registers on the
top
mark of
the dipstick (Fig. 6). Use premium quality 4-stroke engine oil
-
SAE10W30
recommended oil for Australia and New Zealand.
Note.
The Oil Alert System will automatically stop the engine
before the oil level falls below the safe limit. However, to
avoid the inconvenience of an unexpected shutdown, it is still
advisable to visually inspect the oil level regularly.
PRE-OPERATION CHECK (cont.)
CAUTION!
Using non-detergent oil or 2-stroke engine oil could shorten the
engine’s service life.
REMOTE CONTROL
12V DC 8.3A
12 V APPLIANCE OUTLET 8.3A
5V DC USB
BATTERY POWER
OVERLOAD RUN LOW OIL
STOP
ECONOMY
ON
ON
OFF
240V
OFF
STOP
START
ON
DC OVERLOAD
RESET
Upper
level
allowed
Fig. 5
Fig. 6
Fig.
4
Summary of Contents for SD2200i
Page 3: ...3 KNOW YOUR PRODUCT cont...
Page 29: ...29...
