Fukuda Denshi LX-5630, Operation Manual, Page: 6 / 41

iv
CAUTION
5. Cares after Operation
· Disconnect the cables by holding the connector plugs. Do not apply excessive
force to cords by pulling.
· Keep the equipment clean in preparation for the next use.
6. If the equipment is out of order, ensure patient safety by immediately
turning the equipment off and disconnecting electrodes and/or
transducers from the patient.
Contact your nearest Fukuda Denshi representative and label the
device as "OUT OF ORDER".
7. Do not disassemble or attempt service on the equipment. Contact
your nearest Fukuda Denshi representative for service.
8. Maintenance and Inspection
· Be sure to perform periodic inspection of the equipment and accessories.
· Before operating the equipment which has not been used for a long period of time,
make sure that the equipment operates normally and safely.
9. When using an electrosurgical unit or defibrillator in conjunction
with this equipment, take care of the following.
· The high-frequency energy produced by electrosurgery equipment may result in
burns to the patient or possible damage to the equipment. Be sure to observe the
precautionary instructions described in the operation manual of the electrosurgical
unit.
· Some types of equipment may be damaged by the energy discharged by a
defibrillator. Ensure a thorough understanding of the precautionary instructions
described in the operation manual of the equipment before using a defibrillator.
· Some types of equipment other than electrosurgical units and defibrillators may
cause accidental hazards to the patient and operator when operated under adverse
conditions. Read the operation manual attached to each individual unit and
understand the precautionary instructions prior to use.