Fujitsu ST4120P, User Manual

Page: 51 / 77

A g e n c y N o t i c e s
41
Regulatory Information
NOTICE
Changes or modifications not expressly
approved by Fujitsu could void this user’s
authority to operate the equipment.
FCC NOTICES
Notice to Users of Radios and Television
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses, and can radiate radio frequency energy
and, if not installed and used in accordance with
the instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is encouraged
to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet that is
on a different circuit than the receiver.
• Consult the dealer or an experienced radio/
TV technician for help.
Shielded interconnect cables must be
employed with this equipment to ensure
compliance with the pertinent RF emission
limits governing this device.
Notice to Users of the US Telephone Network
Your Tablet PC may be supplied with an
internal modem which complies with Part 68 of
the FCC rules. On the system is a label that
contains the FCC Registration Number and the
Ringer Equivalence Number (REN) for this
equipment among other information. If
requested, the user must provide their
telephone company with the following
information:
1. The telephone number to which the
computer is connected.
2. The Ringer Equivalence Number (REN) for
this equipment.
3. The equipment requires a standard modular
jack type USOC RJ-11C which is FCC Part
68 compliant.
4. The FCC Registration Number.
This equipment is designed to be connected to
the telephone network or premises wiring
using a standard modular jack type USOC RJ-
11C which is FCC Part 68 compliant and a line
cord between the modem and the telephone
network with a minimum of 26AWG.
The REN is used to determine the number of
devices that you may connect to your
telephone line and still have all of those
devices ring when your number is called. Too
many devices on one line may result in failure
to ring in response to an incoming call. In most,
but not all, areas the sum of the RENs of all of
the devices should not exceed five (5). To be
certain of the number of devices you may
connect to your line, as determined by the
RENs, contact your local telephone company.
If this equipment causes harm to the telephone
network, your telephone company may
discontinue your service temporarily. If
possible, they will notify you in advance. If
advance notice is not practical they will notify
you as soon as possible. You will also be
advised of your right to file a complaint with the
FCC.
This fax modem also complies with fax
branding requirements per FCC Part 68.
Your telephone company will probably ask you
to disconnect this equipment from the
telephone network until the problem is
corrected and you are sure that the equipment
is not malfunctioning. This equipment may not
be used on coin-operated telephones provided
by your telephone company. Connection to
party lines is subject to state tariffs. Contact
your state’s public utility commission, public
service commission or corporation commission
for more information.
Changes or modifications not expressly
approved by Fujitsu could void this user’s
authority to operate the equipment
Alb Passive 5(39-44) 25/3/03, 11:57 AM 41