Fujitsu ST4120P User Manual Download

Page: 32 / 77

F u j i t s u S t y l i s t i c S T 4 1 2 0 P / 2 1 P Ta b l e t P C U s e r ’s G u i d e - S e c t i o n O n e

• The suspend action of the Suspend/Resume

button may be disabled to prevent accidental
interruption. If this is the case, pressing the
Suspend/Resume button will not suspend
system operation as described here. (In this
case, suspend mode can only be achieved
using the system software). Contact your
local help desk or reseller if your system
configuration is not suitable.

• If your system is equipped with a PC Card that

allows you to connect to a wired or wireless
network, you may be logged off the network
after a period of inactivity while system
operation is suspended. Contact your network
administrator or help desk for details on log-off
parameters for your network.

RESUMING SYSTEM OPERATION

To resume system operation from either
Suspend-to-RAM or Hibernate modes, press the
Suspend/Resume button.

• From Suspend-to-RAM mode

Status lights indicate that the system state is
changing. It may take up to a minute before the
system returns to the On state and system
operation resumes. Note that the display turns on
shortly before the pen becomes active due to the
power-up sequences observed by the system.

• From Hibernate (Save-to-Disk) mode

Active data is read from the hard disk drive,
and the system returns to the On state after a
short time.

Note that power to several system
components must be restored before
system operation resumes. Allow
sufficient time for system operation to
resume before attempting to use the
system. If your system uses Hibernate
mode, it will take longer to resume
operation as compared to using Suspend-
to-RAM mode. Time is needed to read
data from the hard disk drive.

• Use the system as you normally would once

system operation resumes.

All programs resume at the point where execution
stopped when system operation was suspended.

USING THE PEN

You can use the Fujitsu Stylistic ST4120P/21P
Pen to select items, and to navigate through
programs on the Pen Tablet PC. The pen can
be used like a two button mouse when used in
conjunction with the right-mouse button.

• Ensure that a screen protector is

installed on the Pen Tablet PC screen
before you use the pen. The warranty
does not cover a screen that is
scratched as a result of not using a
screen protector.

• Use only the pen provided with your Pen

Tablet PC. Do not use substitutes that
were not designed for the Fujitsu
Stylistic ST4120P/21P Tablet PC. (e.g.,
ball point pens, fingernail, or
screwdriver). Damage caused by using
an instrument other than the provided
pen is not covered by the system
warranty.

Here are some hints on using the pen similar to a
two-button mouse on a desktop system:

• To select an object, tap the pen tip on the

object once. This functions like a left mouse
button click.

• To “double-click” an object, tap twice on

the object quickly. (The pen double-click
speed is in sync with the mouse double-click
speed, and can be changed by going to
Start -> Settings -> Control Panel -> Mouse.

• To generate a “right mouse button single-

click”, press the Right-Click Application

Button

, then tap on the object once.

• To move, or “drag”, an object on the

screen, place the pen tip directly over the
object, then as you hold the pen tip against
the screen, move the pen.

Alb Passive 2(17-28)

25/3/03, 11:54 AM